FiltersDone

Question type

Essay

Multiple Choice

Short Answer

True False

Matching

Exam 24: Chrysler 6 Speed 62te Transmission

Show Answer

Share

---

All types

Filters

Study FlashcardsPractice ExamLearn

Question 21

Multiple Choice

Review LaterAdd Note

Review Later

An old speedometer cable is used to check the transmission fluid level of 62TE. Tech A states that the bottom of the cable should be marked at 20 and 30 mm. Tech B states that the bottom of the cable should be marked at 40 and 50 mm. Who is correct?

A) Tech A
B) Tech B
C) Both A and B
D) Neither A and B

Correct Answer

verified

Show Answer

Question 22

Multiple Choice

Review LaterAdd Note

Review Later

A vehicle comes into the shop with the transmission stuck in 1st gear. Tech A states this could be caused by a failed output shaft speed sensor. Tech B states this could be caused by a faulty underdrive clutch. Who is correct?

A) Tech A
B) Tech B
C) Both A and B
D) Neither A nor B

Correct Answer

verified

Show Answer

Question 23

Multiple Choice

Review LaterAdd Note

Which of these is a common wear item and should always be replaced?

The solenoids on a Chrysler 62TE transmission are being discussed. Technician A says that there are only 9 solenoids that operate the transmission. Technician B says that the solenoids cannot be tested directly but can be tested through the main connector. Who is correct?

Tech A states that the entire speedometer cable needs to be inserted inside the transmission to check the fluid level. Tech B states that it is very easy to push the speedometer cable past the dipstick stop inside the transmission. Who is correct?

Rebuilding the Chrysler 62TE transmission is being discussed. Technician A says that photos should be taken throughout the disassembly process to aid during the reassembly of the transmission. Technician B says that the latest service information should be followed because a different version of the transmission might be being serviced. Who is correct?

Input housing reassembly for a 62TE transmission is being discussed. Technician A says that a new overdrive o-ring seal should be installed only after the overdrive reverse piston, spring, and snap ring have been assembled. Technician B says to reuse the orifice in the overdrive/reverse piston, being sure to stake into place. Who is correct?

When checking the fluid level, the exact temperature of the fluid can be determined using a(n) :

When using an old speedometer cable to check the transmission fluid level of 62TE, a paint marker should be used to mark a line at ________ from the end of the cable.

After removing the four bolts that retain the compounder, what tool is used to remove it from the the transmission case of a 62TE?

The 62TE transmission requires transmission fluid called ATF+4.

Choose the correct statement with respect to disassembling the 62TE transmission.

Before removing the front pump with the proper tool, how many fasteners need to be removed to allow pump removal on the Chrysler 62TE transmission?

The Chrysler 62TE transmission uses a variable force control solenoid to control __________.

All of the following statements with respect to the fourth prime ratio are true except:

Double swap shift means that when the transmission shifts from second gear to third gear, ________.

You are rebuilding a 62TE transmission. You measure the input shaft end play and find that the end play is 0.032 inches (0.81 mm) . The thrust plate in the transmission is a 0.053 inches (1.34 mm) . Which thrust plate would you select to correct the problem?

Tech A states that the additional gear ratios in the 62TE were created by replacing the transfer shaft in the 41TE. Tech B states that 62TE retains the transfer shaft used in the 41TE. Who is correct?

All of the following statements with respect to rebuilding the low clutch housing are true except:

Technician A says that some of the solenoids of the Chrysler 62TE transmission allow fluid to flow to their assigned clutch when they are de-energized and stop flow to their clutches when energized. Technician B says that some Chrysler 62TE transmissions will stop the flow of fluid to their solenoids when they are de-energized and will allow flow to their clutches when energized. Who is correct?